Heatmiser Touch-RF, Manual

Page: 10 / 36

9
Wireless Series
Section Header
Pairing With the RF-Switch Receiver
With the thermostat turned ON:
• Press PROG then SETUP ....................................................................................................................
• Press the Up key at the top of the screen to select feature 06 ................................................
The options within feature 06 are: 00 = UH8-RF or 01 = RF-Switch receiver.
• Use the Up/Down keys (centre screen) to set feature 06 to 01(RF-Switch) ................
• Press “DONE” to confirm setting ...........................................................................................................
• The heating output can be paired to CH 1 or Boiler CH depending on which you
have chosen. If the thermostat is set to heating and hot water mode the hot water output
will automatically pair to channel 2 HW.
• On the RF-Switch receiver, press and hold the CH1 Pairing button (if a valve is used) or Boiler
CH Pairing button until the Comms LED flashes.
• With the thermostat turned ON, press & hold the “SCREEN” button for
5 seconds .........................................................................................................................................................
• The thermostat will send a signal and show “PAIR RF” & the RF icon in the display .........
• If pairing is successful, the Comms LED on the RF-Switch receiver will go out.
If pairing is unsuccessful, check features 06 to 07 have been configured correctly. To eliminate
a possible signal issue, reposition the thermostat closer to the receiver and repeat the pairing
process again.