Heatmiser neoAir, Instruction Manual

Page: 30 / 44

29
Series
Section Header
Feature 08 – Optimum Start:
Optimum start will delay the start-up of the heating system
to the latest possible moment to avoid unnecessary heating and ensure the building is
warm at the programmed time. The thermostat uses the rate of change information to
calculate how long the heating needs to raise the building temperature 1°C (with a rate
of change of 20, the thermostat has calculated the heating needs 20 minutes to raise the
building temperature 1°C) and starts the heating accordingly.
Feature 09 - Rate of Change:
Number of minutes for 1°C temperature rise.
Feature 10 –
Not used on this model.
Feature 11 – Not used on this model.
Feature 12 – Program Mode:
Non-Programmable, Weekday/Weekend (5/2), 7 Day
Programming or 24 Hour. The thermostat offers three programming modes and the option
of configuring it to work as a non-programmable thermostat.
Weekday/ Weekend -
allows you to program 4 comfort levels for the weekday and
4 different comfort levels for the weekend.
7 Day Program Mode -
Each day has 4 comfort levels that can be programmed
independently.
24 Hour Mode -
All days are programmed the same and repeat continuously.
Feature 13 - Temperature Format: This function allows you to select between °C and °F.
Feature P1 - Pairing: to the RF-Switch.
Feature P2 - Setting the UH8-RF address:
This is the number set on the rotary dials inside
the UH8-RF unit.
Feature P3 - Failsafe: If the RF-Switch or UH8-RF fails to receive a signal from the thermostat
within 40 minute period, it will activate to output for 12 minutes every hour. The RF-Switch/
UH8-RF will continue to do this until it receives a new signal from the thermostat.