36
Heatilator • Eclipse • 4049-300 Rev H • 11/07
H. Install Floor Cover
Place
fl
oor cover (painted side up) as shown in Fig-
ure 12.14.
I. Grilles and Screen
• Lay top grille face down so the thin tabs are pointing up.
• Spread screen out next to the tab side of the grille.
• Starting with one corner of the screen, thread the
fi
rst loop
of the screen over the
fi
rst tab on top grille and continue
threading the screen over tabs along edge of top grille.
Adjust screen so it lays evenly (not bunched or too tight
between tabs).
G. Install Surround Top
• Apply 1/4 in bead of high temperature silicone caulking
approximately 1 in. from the outside edge of both top
surround pieces. Refer to Figure 12.10. Do not get caulking
in switch channel of right top surround.
• Mount left top surround by engaging slots in brackets with
screws holding top trim strip.
• Gently press surround against wall while aligning edge of
top surround with edge of surround leg.
• Adjust trim strip so edge is in the groove in surround
edge.
• Tighten only the outside screw to temporarily hold surround
in place. Edges on surround top and surround leg may not
match up at this time, adjustments will be made later.
• Hold right surround top close to appliance and snap off/on
switch in slot on back side of surround. Run switch wire
down to end of channel and hold in place with a piece of
heat resistant tape (not provided). See Figures 12.13 and
12.14.
Switch in Slot
Tape
Holding
Wire
Figure 12.13 Place Switch in Slot, Tape on Wire
• Mount right top surround to appliance in the same matter
as left top surround, aligning outside edges of the surround
top and leg.
• Gently press surround to wall and tighten both outside
and inside screws of both top surround pieces.
• Dry
fi
t the keystone piece. If it
fi
ts, proceed to the next stop.
If it does not, minor adjustments can be made by loosening
screws on surround pieces and gently adjusting them in
or out, left or right until all edges match and keystone
fi
ts.
Apply 1/4 in. diameter bead of high temperatur silicone
caulking to backside of keystone approximately 1 in. from
the top edge and gently place keystone in place.
Figure 12.14 Place Floor Cover
Tab
Figure 12.15 Lay Out Screen
