7065-132I • May 18, 2017
18
www.heatilatorecochoice.com
• Frequency:
As desired
• By:
Homeowner
• Clean glass with a non-abrasive glass cleaner. Abrasive
cleaners may scratch and cause glass to crack.
• If the deposits on the glass are not very heavy, normal
glass cleaners work well. Heavier deposits may be
removed by using a damp cloth dipped in wood ashes or
by using a commercially available oven cleaner.
• After using an oven cleaner, it is advisable to remove any
residue with a glass cleaner or soap and water. Oven
cleaner left on during the next firing can permanently stain
the glass and damage the finish on plated metal surfaces.
• A portion of the combustion air entering the firebox is de
-
flected down over the inside of the door glass.
• This air flow “washes” the glass, helping to keep smoke
from adhering to its surface.
• When operated at a low burn rate, less air will be flowing
over the glass and the smoky, relatively cool condition of
a low fire will cause the glass to become coated.
•
Operating the appliance with the Burn Rate Air Control all
the way open for 15-20 minutes should remove the built
up coating.
CAUTION! Handle glass assembly with care. Glass is
breakable
.
• Avoid striking, scratching or slamming glass
• Avoid abrasive cleaners
• Do not clean glass while it is hot
Replace the firebrick if they become crumbly and/or if there
is a 1/4 inch (6.35mm) gap between the bricks.
The firebox is lined with firebrick, which has exceptional in
-
sulating properties. Do not use a grate; simply build a fire on
the firebox floor. Do not operate appliance without firebrick.
1. After the coals have completely cooled, remove all old
brick and ash from appliance and vacuum firebox.
2. Remove new brick set from box and lay out to the diagram
shown in the instructions that come with the replacement
brick set.
3. Lay bottom bricks in appliance.
4.
Install rear bricks on the top of the bottom bricks.
5. Install side bricks. Slide top of brick under clips on side
of firebox and push the bottom of the brick until it is flush
with the side of the appliance.
• Frequency:
After each ash removal
• By:
Homeowner
Use Part 832-0550 when ordering individual brick. Provide
brick dimension or copy the page in the service parts list, mark
the desired brick and take it to your authorized dealer.
D. Glass Cleaning
E. Firebrick Inspection & Replacement