Heatilator • Caliber Mesh CD Series-SIT Valve • 4040-849 Rev H • 11/07
49
Handle glass doors with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass
door removed, cracked, broken or
scratched.
• Replace glass door assembly as a
complete assembly.
WARNING
J. Install Trim
• Install optional marble and brass trim surround kits using
the installation instructions included with them.
• Marble, brass, brick, tile or other non-combustible
materials can be used to cover gap between sheet rock
and appliance.
• Do not obstruct or modify the air inlet/outlet latch
covers.
• Allow space to lower and remove the bottom latch
cover.
I. Glass Assembly
• Removing
Glass
Assembly
Lift and pull the upper latch cover towards you to expose
the two (36 in. model) or three (42 in. model) Quick Access
Latches. Lift and pull lower latch cover to expose the
two (36 in. model) or three (42 in. model) Quick Access
Latches. Rotate the bottom of the screen assembly away
from the appliance and lower out of the top retainers.
Release the top and bottom access latches and rotate
the top of the glass assembly away from the top of the
appliance. Place the glass assembly on a surface that will
not scratch the surface of the glass assembly.
• Replacing Glass Assembly
Replace the glass assembly on the lower access latches
and rotate the upper portion of the glass assembly into
place. Engage the top access latches. Engage the lower
access latches.
• Reinstall upper latch cover (see Figure 12.12).
• Reinstall lower latch cover (see Figure 12.14).
• Reinstall
mesh
fi
rescreen (see Figure 12.15).
Latches
(both bottom
and top)
Glass
Assembly
Figure 12.8 Glass Assembly
Bottom Latch Cover
(Lower Floor Cover underneath)
Firescreen
Firescreen Rod
Hood
Top Latch Cover
K. Install Clean Face Components
Carefully remove components from skin pack. See Fig-
ure 12.9 for identi
fi
cation of components.
Install Hood
• Bend screen rod tabs down at a 90-deg. angle. See
Figure 12.10.
Figure 12.10 Screen Rod Tab
Figure 12.9 Clean Face Components/Skin Pack