5
598-1159-06
SPECIFICATIONS
Range . . . . . . . . . . . . Up to 60 ft. (18.3 m) [varies with
surrounding temperature].
Sensing Angle . . . . . . Up to 110°
Electrical Load . . . . . . Up to 150 Watts Maximum tung-
sten
Power Requirements . 120 VAC, 60 Hz
Operating Modes . . . . TEST, AUTO and MANUAL
MODE
Time Delay . . . . . . . . 1, 5, 10 minutes
Range . . . . . . . . . . . . Adjustable
Replacement lamp . . . T 150W (or less) halogen 120
VAC
HeathCo LLC reserves the right to discontinue prod-
ucts and to change specifications at any time without
incurring any obligation to incorporate new features
in products previously sold.
TROUBLESHOOTING GUIDE
SYMPTOM
Light will not
come on.
Light comes on
in daylight.
Light comes on
for no apparent
reason.
POSSIBLE CAUSE
1. The halogen lamp is positioned too
close to the light control's sensor or
pointed at nearby objects that cause
heat to trigger the sensor
(Reposition
the lamp away from the sensor or
nearby objects)
.
2. Light control's sensor is pointed toward
a heat source like an air vent, dryer
vent, or brightly-painted heat-reflective
surface
(Reposition sensor)
.
3. Light control is in Manual Mode.
(Switch to Auto.)
1. Heat or light from the halogen lamp
may be turning the light control on
and off
(Reposition the lamp away
from the sensor)
.
2. Heat being reflected from other
objects may be affecting the light
control
(Re-aim sensor)
.
3. Light control is in the TEST mode
and warming up
(Flashing is normal
under these conditions)
.
SYMPTOM
Light stays on
continuously.
Light flashes
on and off.
POSSIBLE CAUSE
1. Light switch is turned off.
2. Halogen lamp is loose or burned
out.
3. Fuse is blown or circuit breaker is
turned off.
4. Daylight turn-off is in effect
(Recheck
after dark)
.
5. Incorrect circuit wiring, if this is a new
installation.
6. Not aimed correctly
(Re-aim the
sensor to cover desired area)
.
1. Light control may be installed in a
relatively dark location.
2. Light control is in TEST
(Select 1, 5
or 10 minutes for AUTO time)
.
1. Light control may be sensing small
animals or automobile traffic
(re-aim
sensor)
.
2. Sensitivity is set too high
(Reduce
sensitivity)
.
