5
598-1348-00
Least Sensitive
Most Sensitive
The sensor is less sensitive to motion directly
towards it and more sensitive to motion across
coverage area.
Sensor
Motion
Motion
sPeciFicatiOns
Range ........................... Up to 30 ft. (9.1 m)
[varies with surrounding
temperature].
Sensing Angle .............. 360°
Electrical Load .............. Up to 75 Watt Maximum
Tungsten Incandescent
(Up to 25 Watt Maximum
each lampholder).
Bulb Type ...................... Candelabra Base, Type
“B”, 25 Watt Maximum
Sensor Capacity ........... Up to 200 Watt (1.7 A.)
Maximum Tungsten
Incandescent
Power Requirements .... 120 VAC, 60 Hz
Operating Modes .......... TEST, AUTO/ACCENT,
and MANUAL MODE
ON-Timer ...................... 1, 5, 10 minutes
D
ual
B
rite
®
Timer .......... Off, 3, 6 Hrs, Dusk-to-
Dawn
HeathCo LLC reserves the right to discontinue
products and to change specifications at any time
without incurring any obligation to incorporate new
features in products previously sold.
adJustment OF cOverage
area
The sensor on this light fixture detects “motion”
by the movement of heat (body heat) across the
coverage area. However, following are examples
of objects that also produce heat and can cause
the sensor to false trigger:
• Pools of Water
• Air Conditioners
• Dryer Vents
• Fenced-In Animals
• Heating Vents
• Automobile Traffic
If you suspect that a heat source of this type is falsely
triggering the sensor and reducing the sensitivity
does not solve the problem, then a lens shield
(included) can be installed. The plastic lens shield
is divided into 6 sections. Each section will reduce the
coverage angle by 30 degrees. Also, the tip of each
section may be removed to change the effective
range of the sensor.
1. Break off the
amount of lens
shield needed
to block the de-
sired area of
coverage.
2. Cut desired
amount of foam
tape needed to
adhere the lens
shield to the sensor lens.
3. Remove paper backing from one side of cut
foam tape and adhere foam tape to inside of
lens shield.
4. Remove paper backing from other side of cut foam
tape and adhere lens shield to sensor lens.
5. Retest to confirm that the sensor is no longer
false triggering.
Note:
To help determine amount of lens shield
required, apply small sections one at a time. Ad-
ditional sections can be applied if necessary.
Area
Blocked
Area
Blocked
Lens
Shield
Lens
Shield
Portion
Removed
Effective
Coverage Area
(Top View)
Lens Shield
Sensor Lens
DU
AL
BR
ITE
®
ON
-TI
ME
TEST
1 5
10
MIN
OF
F 3
6
D
USK
TO
DA
WN
