4
598-1136-03
AM
PM
A
A
B
ON
OFF
ON
OFF
DIM
GROUP
MODE
ALL
ON
ALL
OFF
PANIC
DIM
ON
OFF
ON
OFF
DIM
DIM
ON
OFF
ON
OFF
DIM
DIM
ON
OFF
ON
OFF
DIM
DIM
–
Select
Time Set
Program
+
1
2
EXAMPLE 1 – Set Up Receivers
Following is one example of how the Lighting Control Panel can be programmed
to operate multiple light sources within a home.
The Control Panel has two “Groups” (A and B) with up to eight lighting controls
in each group. In this example, the eight controls within Group A will operate the
following light sources: Family Room (3), Kitchen, Front Porch, Back Porch,
Garage, and Foyer.
Light: Family Room Lamp #1 and #2
Receiver: Plug-In (1 per lamp)
Plug-In Code Setting:
1 2 3 4
Light: Family Room Lamp #3
Receiver: Wall Receptacle
Receptacle Code Setting:
1 2 3 4
Light: Kitchen
Receiver: Wall Switch
Wall Switch Code Setting:
1 2 3 4
Light: Front Porch
Receiver: Wall Switch
Wall Switch Code Setting:
1 2 3 4
Light: Family Room Ceiling Light
Receiver: Wall Switch
Wall Switch Code Setting:
1 2 3 4
Light: Foyer
Receiver: Wall Switch
Wall Switch Code
Setting:
1 2 3 4
Light: Garage
Receiver: Lamp Socket
Lamp Socket Code
Setting:
1 2 3 4
Light: Rear Porch
Receiver: Floodlight
Floodlight Code Setting:
1 2 3 4
Group LED
“A”-LED On (Shown)
“B”-LED Off
A
Set code switch 4 on receivers to Group
A setting (down) for all receivers to
operate in Group A.
Set code switches 1 through 3 on re-
ceivers to match the corresponding
control setting in above example.
To Operate:
1.
Press Group A button (
Note: Group
A LED will be ON).
2.
Press corresponding control but-
ton for desired action of selected
light source.
To set receivers to work with Group B
controls, slide code switch 4 to Group B
(up) on receivers and set code switches
1 through 3 as shown above.
Possible Light Sources for Group B:
• Bedroom #1 (Wall Switch)
• Bedroom #2 (Wall Switch)
• Master Bedroom (Wall Switch)
• Master Bedroom Lamp #1 (Plug-In)
• Master Bedroom Lamp #2 (Plug-In)
• Master Bath (Wall Switch)
• Closet (Lamp Socket Converter)
• Hall Ceiling Light (Wall Switch)
ON
1 2 3 4
Note: The “X” has been
placed on the switches
to help clarify the code
settings on this page.
Light: Family Room Lamp #1 and #2
Receiver: Plug-In (1 per lamp)
Plug-In Code Setting:
Code Selection
Switches
Group Selection
Switch (Group A
Shown)
