34
Heat & Glo • 6000BEC-IPI, 6000BEC-IPILP • 2187-900 Rev. K • 4/15
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE:
Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
A. Top Vent
9
9
Appliance Preparation
Figure 9.1
Cut the seal cap strap across the rectangles
next to the disk.
Figure 9.2
Remove the white gasket material covering
the seal cap.
Figure 9.3
Remove the seal cap.
Figure 9.4
Remove the insulation basket and white insula-
tion from the center vent pipe.
Figure 9.5
Remove the insulation from the outer vent
pipe. For rear venting there is no insulation in the outer
vent pipe.
NOTICE:
Once the seal cap has been removed it CANNOT
be reattached.
Figure 9.6
To attach the
fi
rst section of vent pipe, make
sure to use the
fi
berglass gasket in the manual bag to seal
between the
fi
rst vent component and the outer
fi
replace
wrap. Use 2 self tapping screws to secure the gasket to
the outer wrap.
Secure the
fi
rst section of venting to the
fi
replace by screw-
ing through the two straps left over from cutting the seal
cap strap in step 2.
