Heat Surge Accent, Manual

Page: 5 / 36

Function
The thermostat will cycle the heater on and off when the temperature of the room is -1 degree of the dial setting. when
the heater is shut off by the thermostat, the heat indicator lights will remain illuminated and the fan will continue to blow for
approximately 20 seconds to cool down the heating elements. The fan will also turn on for 30 seconds approximately every 7
minutes to clear the fireplace of heated air to ensure an accurate room temperature reading by the thermostat.
Setting the Thermostat
First confirm that the thermostat is turned to HiGH (all the way to the right). next turn the main power on the heating unit on.
Then turn either the lOw or HiGH heat mode button on. allow the room to heat up to the desired temperature. Once the
desired temperature is reached, slowly turn the thermostat knob counter clockwise (left) until a click is heard. leave the knob
in that position. The heating unit will now shut down. The thermostat is now set at the room temperature. *note: You can adjust
the knob higher or lower slightly to fine tune the room temperature.
REmOTE CONTROL
(optional product offering)
OPERATION
On the first usage of the remote control, install the batteries: open the battery compartment by sliding the
cover along the arrow, install two aaa batteries according to the markings on the compartment, and slide the
cover back into its original position. if no batteries are installed or the batteries are defective, the remote will not
function.
bUTTONS AND INDICATORS
The receiver for the remote control is mounted behind the flame image board inside the fireplace.
FLA
Me UP
FLA
Me
dOW
N
ON/Off bUTTON
The fireplace’s on/off button supplies the
main power to the fireplace.
fLAmE UP bUTTON
The flame up button is used to increase the
brightness of the flame and embers. Press once,
you will hear a beep and the brightness will increase
by (1) brightness setting. There are (15) preset
brightness settings. when no more beeps are
heard, the fireplace is set at the brightest setting.
fLAmE DOWN bUTTON
The flame down button is used to decrease
the brightness of the flame and embers. Press
once, you will hear a beep and the brightness will
decrease by (1) brightness setting. There are (15)
preset brightness settings. when no more beeps
are heard, the fireplace is set at the darkest setting.
hEATER LOW mODE bUTTON
The heater low button is used to turn the
heater on or off in the low power setting.
hEATER hIGh mODE bUTTON
The heater high button is used to turn the
heater on or off in the high power setting.
BATTERY BOX
4
fIREPLACE CONTROL PANEL (CONTINUED)
ThERmOSTAT (some models)
initial Setup
Upon arrival of the fireplace, the thermostat will be set to the highest setting
(turned all the way right). This is done to ensure your fireplace unit will always
turn on regardless of the room temperature. *note: always make sure the
thermostat knob is turned all the way to the right prior to troubleshooting
heating issues.