26
POSITIONING THE LOGS
Figure 27
NOTE: Logs are identified by
number, handle logs gently.
1.
With the knot on the bottom left
hand side, place Log #1 on the
grate. The back of the log should
be placed against the two tabs on
the right side of the grate. The
rear corner of the log should rest
against the tab at the center of
the rear bar.
2.
Rest the back of Log #2 against
the two front tabs. Position this
log so that there is a 1/4 gap
between the burned top on the
right hand side of Log #2 and the
edge of Log #1.
3.
Grasp Log #3 with the bark side
up and the burned sections
facing towards the left. Place the
rear of the twig against the long
tab at the rear of the log grate
and rest it on the right edge of
Log #2.
4.
Place Log #4 on top of the base
log #1 so that the burned
sections line up with each other.
Keep this log as far back on the
large log as possible.
5.
Place the burned tip of log #5 on
top of log #3. Place the other end
of log #5 against the locator at
the left hand front corner of the
burner.
6.
Gently place glass assembly and
trim door. Close lower access
door. If sooting occurs, the logs
might need to be repositioned
slightly to avoid excessive flame
impingement.
1
2
3
4
5
1
2
3
4
5
