6
1
Approvals and
Codes
High Altitude Installations
U.L. Listed gas appliances are tested and approved for
elevations from 0 to 2,000 feet in the U.S.A. and from 0 to
4,500 feet in Canada.
When installing this appliance at an elevation above 2,000
feet (in the United States), it may be necessary to decrease
the input rating by changing the existing burner orifice to a
smaller size. Input should be reduced four percent (4%) for
each 1,000 feet above sea level, unless the heating value of
the gas has been reduced, in which case this general rule
will not apply. To identify the proper orifice size, check with
the local gas utility.
When installing this appliance at an elevation between 2,000
and 4,500 feet (in Canada), the input rating must be reduced
by ten percent (10%).
When installing this appliance at an elevation above 4,500
feet (in Canada), check with local authorities.
Consult your local gas utility for assistance in determining
the proper orifice for your location.
Heat-N-Glo Quality
Systems registered
by SGS ICS
Appliance Certification
The Heat-N-Glo appliance model discussed in this
Installers
Guide
has been tested to certification standards and listed
by the applicable laboratories.
Certification
MODEL:
BAY-STOVE
LABORATORY:
Underwriters Laboratories
TYPE:
Direct Vent Gas Fireplace Heater
STANDARD:
ANSI Z21.88CSA2.33UL307B
NOTE: ALL MODELS ARE UL LISTED TO UL307B, THE
STANDARD FOR GAS-BURNING HEATING APPLIANCES
FOR MANUFACTURED HOMES AND RECREATIONAL
VEHICLES.
Installation Codes
The appliance installation must conform to local codes.
Before installing the appliance, consult the local building
code agency to ensure that you are in compliance with all
applicable codes, including permits and inspections.
In the absence of local codes, the appliance installation
must conform to the National Fuel Gas Code ANSI Z223.1
(in the United States) or the CAN/CGA-B149 Installation
Codes (in Canada). The appliance must be electrically
grounded in accordance with local codes or, in the absence
of local codes with the National Electric Code ANSI/NFPA
No. 70 (in the United States), or to the CSA C22.1 Canadian
Electric Code (in Canada).
These models may be installed in a bedroom or bed-sitting
room in the U.S.A. and Canada.
