29
®
Link
Heat
Link
Pure
®
Link Plus
1"
3/4"
1/2"
F
S
F
S
F
S
Use GO gauge here
PEX
Size
Pressed Sleeve Max.
Diameter
1⁄2"
0.645" (16.38 mm)
3⁄4"
0.890" (22.61 mm)
1"
1.135" (28.83 mm)
Jaw
Size
Collar Replacement Kit
Part #
1⁄2"
11435.3
3⁄4"
11435.4
1"
11435.5
Each collar half can only be installed in
corresponding top or bottom jaw of the HeatLink
Confined Space Press Tool.
Replacement collars are sold as pairs, and must
be replaced as pairs to avoid uneven presses.
Replacement Collars for 11435 3-in-1 Press Tool
Each HeatLink® #11435 Confined Space Press Tool comes with 3 collar sets to press
stainless sleeves for 1⁄2", 3⁄4" and 1" PEX. HeatLink recommends that a set of collars always be
kept in the tool jaws.
Changing Collars:
1. To change collars, pull back on the
moving handle so the open jaws
can be held open with one hand.
2. Rotate the top collar CCW and the bottom collar
CW to unlock them. The collars can now be
removed.
3. Insert the top collar and
turn it CW to lock it in
place. Insert the bottom
collar and turn it CCW to
lock in place. Release the
handles.
≥90°
8. Because this is a multi stage tool, every press must be inspected using the Go Gauge
(#11433.1). The Gauge should freely rotate around the press sleeve at least 90°, catching
only on the high spot where the jaws met during pressing. If a press does not pass, the
sleeve and the fitting must be removed and replaced with new. This may indicate the
tool or collars (see below) need to be replaced.
