Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Owner’s Manual • 2310-971 Rev. G • 9/15
10
E. Before Lighting Appliance
Before operating this
fi
replace for the
fi
rst time,
have a
quali
fi
ed service technician
:
• Verify all shipping materials have been removed from
inside and/or underneath the
fi
rebox.
• Review proper placement of logs and media, if installed.
• Check the wiring.
• Check the air shutter adjustment.
• Ensure that there are no gas leaks.
• Ensure that the
fi
rebox glass is sealed and in the proper
position and that the integral glass barrier is in place.
• Ensure the appliance is vented with the approved power
vent system: PVI-SLP or PVLP-SLP.
• Ensure the appliance is equipped with HEAT-ZONE-
PRIMO and/or HEAT-OUT-PRIMO.
• Barrier glass is installed properly with “THIS SIDE
OUT” text on outside. See Section 4.C.
• Ensure there is a vertical gap of approximately 3/8 inch
between the bottom of the barrier glass and the transi-
tion media tray for adequate air
fl
ow.
• Verify proper damper adjustment setting. See appli-
ance installation manual.
WARNING! Risk of Fire or Asphyxiation! DO NOT
op-
erate
fi
replace with
fi
rebox glass assembly removed.
