Heat & Glo • ST-36TR-IFT, PIER-36TR-IFT Owner’s Manual • 2482-981 Rev. B • 3/17
12
G. Appliance Break-In
Follow the initial break-in procedure below to cure the
materials used to manufacture the
fi
replace and the
fi
nishing materials around it.
• The fireplace should be run three to four hours
continuously on high.
• Turn the
fi
replace off and allow it to cool completely.
• Remove
fi
xed glass assembly. See Section 4.B.
• Clean
fi
xed glass assembly. See Section 4.
• Replace the
fi
xed glass assembly and run continuously
on high an additional 12 hours.
Note:
Some IPI systems have a safety feature that
automatically shuts down the
fi
replace after 9 hours of
continuous operation without receiving a command from
the remote control. If this occurs, restart the appliance.
NOTICE! Open windows for air circulation during
fi
re-
place break-in.
• Some people may be sensitive to smoke and odors.
• Smoke detectors may activate.
H. Heat Management
Heat Output
The
fl
ame on this model may be adjusted only if an RC-
400 remote control is installed.
If an optional fan is installed, the fan speed is controlled by
adjusting the speed control knob or using the command
on the remote control. If the rheostat included in the
optional fan kit is installed, turn the knob clockwise to
increase the fan speed and counterclockwise to decrease
the fan speed.
