Heat & Glo • GEM-36B • 2095-900 Rev. H • 3/06
31
GRN wire
inside box
Copper
ground attached
to GRN screw with
GRN wire
14/2WG
Cover Plate
outside firebox
Romex
Connector
WHT
WHT
BLK
BLK
D. Junction Box Installation
If the box is being wired from the
OUTSIDE
of the
appliance:
•
Loosen two screws on the Romex connector,
feed the necessary length of wire through the
connector and tighten the screws.
•
Make all necessary wire connections and
reattach the cover plate to the outer shell.
If the box is being wired from the
INSIDE
of the
appliance:
•
Remove the screw attaching the junction box
to the outer shell, rotate the junction box
inward to disengage it from the outer shell (see
Figure 10.2).
•
Loosen the two screws on the Romex connec-
tor, feed the necessary length of wire through
the connector and tighten the screws.
•
Pull the electrical wires from outside the
appliance through this opening into the valve
compartment.
•
Make all necessary wire connections to the
receptacle and assemble the receptacle and
cover to the junction box.
Figure 10.2 Junction Box Detail
NOTE:
Do NOT wire
110VAC to wall switch.
