Heat & Glo • GEM-36B • 2095-900 Rev. H • 3/06
18
Appliance Preparation
7
Í
A. Removing Non-combustible Facing
Material Assembly
The non-combustible assembly is located on the back of
appliance (see Figure 7.1).
Figure 7.1 Non-Combustible Facing Material Assembly
• Hold non-combustible pieces in place.
• Remove and save two screws from both upper brackets
(see Figure 7.1).
• Remove non-combustible pieces.
• Remove and save three screws from lower bracket (see
Figure 7.1).
• Remove 5 screws from upper shelf (see Figure 7.2).
• Bend sheetmetal brace away from unit (see Figure
7.2) until tabs on shelf are released from standoffs.
• Remove 3 screws at bottom of sheetmetal brace
and remove brace from unit.
• Discard brackets, sheetmetal brace and shelf.
• Replace screws in holes where these pieces were at-
tached to appliance.
Handle with care.
•
Non-combustible material may be damaged if dropped.
CAUTION
Figure 7.2 Sheetmetal Brace and Shelf (rear of appliance viewed from appliance front).
Remove screws
from upper
brackets.
L o w e r
Bracket
Î
A
A
A
A
A
D
B
D
D
Standoff
Standoff
Shelf
Sheetmetal
Brace
C
C
A
B
C
D
