Heat & Glo • 6000C, 6000C-IPI, 8000C, 8000C-IPI • 2164-900 Rev. Q • 11/11
63
Figure 7
2
2
3
3
1
1
Log #3 (SRV2164-703)
: Mate the slot located on the bottom of Log #3 with the right log placement tab on top of Log #1.
After slot and tab have been fi tted together, mate the groove located on the bottom of Log #3 with the horizontal grate bar
and slide Log # 3 toward the right until it rests against the far right grate tine (see Figure 7).
Log #4 (SRV2164-704)
: Place Log #4 in the left log indentation on the burner top (see Figure 2). Slide Log # 4 from right
to left under Log #2 to fi t completely and securely into the indentation (see Figure 8). Nose of log #4 should be pulled to fi t
securely against right hand side of log indentation.
RIGHT GRATE TINE
RIGHT GRATE TINE
1
1
2
2
3
3
4
4
Figure 8
Figure 9
Figure 10
1
1
1
1
2
2
2
2
3
3
3
3
4
4
5
5
5
5
6
6
Log #5 (SRV2164-705)
: Place Log #5 in the right log indentation on the burner top (see Figure 2). Ensure the log fi ts
completely and securely in the recessed indentation (see Figure 9). Log #5 should be pulled to the left hand side of log
indentation.
Log #6 (SRV2164-706)
: Mate the groove located on the lower end of Log #6 with the fourth grate tine (from left to right) as
shown in Figure 10. Set the other end of Log #6 on the fl at area located on top of Log #4 (see Figure 9). Log #6 will also
rest against center grate tine. When properly installed, Log #6 will rest securely on all 3 contact points, not allowing move-
ment or shifting.
FLAT AREA
FLAT AREA
LOG CONTACTS GRATE TINES
LOG CONTACTS GRATE TINES
4
4
LOG #6 CONTACTS TOP OF LOG #4
LOG #6 CONTACTS TOP OF LOG #4
NOSE
NOSE
2164-935C