8
www.heartlandMicroPayments.com
Internal Mounting
– Direct on
Machine Panel
3
For Internal mounting directly onto the
machine, please perform the following steps:
1.
Locate a space on the machine that will
properly accommodate the WaveReader.
2.
Using the template supplied on this page, cut out
the area inside the dashed lines. The opening is
2.75” wide and .75” high
. The dashed gray
circles can be used as drill locations for the ¾” drill
(or progressive) bit. After drilling, a jig-saw can be
used to finish the cuts.
3.
The black circles above the gray area should be
drilled using the 3/16” bit.
4.
Insert the WaveReader through the opening. The
four drilled holes should line up with the mounting
holes in the back of the WaveReader.
5.
After making the cut and drilling the holes, attach
the WaveReader to the machine with the
four
screws (3)
provided in the kit. Do not fully tighten
the screws.
6.
Make sure to
level the Wave Reader
on the
machine and fully tighten the mounting screws.
Direct-on-Machine
Template
Note: For all
stack
Speed Queen
models, this process
must be performed
TWICE per
machine.
Make sure there is enough
room to accommodate two
readers!
