7
www.heartlandMicroPayments.com
1
2
3
4
Internal Mounting -
Trim Plate Kit
For Internal mounting using the trim plate kit,
please perform the following steps:
1.
Locate a space on the machine that will
properly accommodate the WaveReader.
2.
Using the template supplied on this page, cut
out the area inside the dashed lines
[1].
The
opening should be
3” square
. The darker
gray circles can be used a drill locations. After
drilling, a jig-saw can be used to finish the
cuts.
3.
Alternatively, you can drill the center hole
[3]
,
and use a
3” circular
punch to remove the
area marked by the dashed, interior circle
[2]
.
4.
After making the cut, attach the WaveReader
to the Surface Mount Cover Plate
(1)
with the
four screws (3)
provided in the kit.
5.
Insert the WaveReader & Front Plate through
the opening.
6.
Attach the
Rear Backing Plate (2)
with the
two nuts (4)
provided in the kit, and finger-
tighten.
7.
Make sure to
level the Wave Reader and
Front Plate
on the machine and fully tighten
the Rear Backing Plate nuts with a 11/32” Nut
Driver or Socket.
Trim-Plate Mounting
Template
Note: For all
stack
Speed Queen
models, this process
must be performed
TWICE per
machine.
Make sure there is enough
room to accommodate two
readers!
