HearthStone Quality Home Heating Products Inc
Tudor Model #8120
16
E
LECTRICAL
C
ONNECTIONS
NOTE:
OPEN VALVE DOOR IN THE LOWER FRONT FOR ELECTRICAL AND GAS
CONNECTIONS.
T
HERMOSTAT
The ON/OFF/T’stat switch or wall mounted
thermostat controls the Tudor. We
recommend installation of the thermostat for
more comfortable performance, however
you may still override the thermostat by
setting the switch to “ON”. The thermostat
controls the unit by “calling for heat.” The
thermostat turns the unit on when the room
is cold, and turns the unit off once the room
is warmed sufficiently. The thermostat is
controlled by a 750 millivolt DC two-wire
circuit.
R
EMOTE
C
ONTROL
There are two different optional remote
controls available for the Tudor. Both of the
remote controls are capable of turning the
unit on and off. One of the optional remotes
also allows you to control the temperature of
the stove, (in the same way the thermostat
controls the heater), from anywhere in the
vicinity of the unit. If “ON” & “OFF” are
the only controls required, Kit #90-56912
can be used. If you would like to control the
temperature via the remote control, use Kit
#90-56914.
Installation instructions are
provided with the kits.
T
HERMOSTAT
P
LACEMENT
The thermostat should be placed in the same
room or living space as the unit. Typically
5’ (1.5m) off the floor and away from any
influences that may cause the temperature in
the vicinity of the thermostat to be
unrepresentative of the room temperature in
general. Such influences might include
strong lighting, a heater vent from the
central heating system, or a nearby drafty
window.
Placement of the thermostat on an inside
wall rather than an outside wall is
preferable. Do not place the thermostat
directly behind or too close to the unit,
otherwise heat from the unit will
immediately satisfy the thermostat and turn
the unit off.
T
HERMOSTAT
W
IRING
The thermostat should be connected to the
Tudor using no more than 40’ (12 m) of the
provided insulated thermostat wire. The
thermostat wire from the Tudor to the
thermostat can be surface mounted or routed
under the floor, through walls, etc.
Be sure to leave a small coil of additional
thermostat wire behind the Tudor so that the
unit can be moved out of position for
servicing and cleaning.
Connect one of the thermostat wires to the
gas control marked
TH
and the other to the
yellow wire coming from the on/off T’stat
switch
.
When making these connections,
position the thermostat wire so that it
extends towards the wall behind the Tudor,
then towards the thermostat.
At the thermostat, the wires should be
connected to the two connection screws on
the back of the thermostat per the
instructions received with the thermostat.
Take care not to over-tighten the connection
screws and not to damage the internal parts
of the thermostat.
