Hearthstone Quality Home Heating Products, Inc.
Bristol DX Model 8762
14
damage is found or suspected, contact your dealer
for instructions.
Always use gloves and eye protection when handling
the decorative ceramic fire logs, and burner. Use
care when handling these parts as they are fragile
and subject to damage and breakage if handled
roughly.
See the firebox access instructions on page 15 and
remove the log set. Unpack and inspect the logs for
damage. Inspect the ceramic burner. Open the other
boxes and inspect the components. If log, burner, or
any other component damage is encountered,
contact your dealer for a replacement. Otherwise, set
the logs and other components aside until called for
during the installation.
Dismounting from Pallet
With the accessory boxes removed and set aside,
remove the 4 lag bolts and clips that fasten the unit to
the pallet (see figure 10). Take care not to mar or
chip the
stove’s finish.
Have someone help lift the stove up and off the
shipping stands and pallet, taking care to avoid
damaging components mounted under the stove.
Figure 9
– Shipping Clip Detail
Leg Leveler Screws
If your hearth surface in uneven, or is not level, you
can use the four provided leveling screws.
1. Completely remove the four carriage bolts
used for shipping the stove.
2. Replace them with the ¼ x 20 x 1
” oval tip
set screws provided in the packing kit.
3. Install the leveling screws down through the
flanges on the feet (hex end up).
4. Adjust the screws only enough to keep the
stove from rocking or wobbling*.
*
On thinner hearths, or hearth pads, adjusting the screws so the
entire stove’s weight is solely supported on them can cause
damage to your hearth.
Shipping Stand
Carriage Bolt
Lag
Bolt
Clip
