20
Vent-Free Gas Log Heater User Manual
Log Placement
Failure to position the parts in accordance with these diagrams or failure to use only parts
Check to ensure that no yellow flame comes in
contact with any log, both after installation and
periodically afterwards. Set the heater to HIGH and check if yellow
flames come into contact with any log. If so, reposition the logs as
indicated in the below illustrations. Yellow flames coming into
contact with logs create unnecessary soot.
CAUTION
Install the logs exactly as indicated (see Fig. 17–20). Do not
modify the logs, and use only logs supplied with the heater. The
logs are numbered and correspond to the numbers listed below.
Number of Logs:
6
1. Place log #1 and #2 onto the
pins in the front grate base.
2. Place log #3 onto the middle
grate base, making sure it’s
aligned with logs #1 and #2.
3. Place log #4 onto the back
grate base, making sure it’s
aligned with logs #1, 2 and 3.
4. Place log #5 so that it’s resting
on logs #1, 3 and 4. Place log #6 so
that it’s resting on logs #2, 3 and 4
Fig. 17
Fig. 20
Fig. 19
Fig. 18
specifically approved with this heater may result in property damage or personal injury.
WARNING
