27
3.1
REMOVAL OF COVERS FOR
SERVICING
A. Control Compartment Grille
Rotate the bottom grille up to access the gas
controls.
B. Trim door and Glass Door
Lift the front trim door up and out away from the
appliance side surrounds. Replace the door when
servicing is complete.
Noting carefully how the brackets fit on the glass,
remove wing nuts and brackets from the glass
door. Release the three spring latches at the top
of the glass door. Carefully lift the glass up and
out away from the appliance. See Figure 30.
3.2 REMOVAL OF COMPONENTS
FOR SERVICE
1. BURNER
Remove the front refractory bracket and carefully lift
up and remove the log set/log grate/refractory as-
sembly.
Unscrew the brackets at both ends of the burner and
slide the burner away from the burner orifice.
2. PILOT ASSEMBLY/IGNITION SYSTEM
Remove the log set/log grate/refractory assembly.
Disconnect the gas supply tube from the underside
of the pilot burner.
Disconnect the electrode wire from the piezo ignitor
(found adjacent to the gas control valve).
Disconnect the attachment nut from the underside
of the thermopile. The thermopile can then be sepa-
rated from the pilot bracket.
Unscrew the pilot assembly bracket and remove.
NOTE:
When removing the pilot assembly, carefully
pull the electrode wire up through the grommeted
hole in the base pan.
3.3 PARTS REPLACEMENT
1. FAN/SWITCHES
Unplug the fan wires from the junction box wires by
pulling the male and female connectors apart and
slide the fan out the front of the lower controls com-
partment.
Disconnect the wires from the fan speed control
switch, pull off the knob, and remove the nut holding
the speed control to the bracket.
Disconnect the wires from the fan temperature sen-
sor switch and remove the nut holding the switch
bracket onto the side of the firebox.
2. GLASS PANEL
To replace the glass door, place the bottom edge
into the lower holders, push glass against unit and
secure the three spring latches at the top. Attach
the brackets at the sides of the glass and hand
tighten the wing nuts.
NOTE:
WING NUTS THAT SECURE THE GLASS
ONLY NEED TO BE HAND TIGHTENED TO GIVE A
SNUG FIT FOR PROPER GASKET SEAL. OVER-
TIGHTENING MAY RESULT IN DAMAGED GLASS.
3. OVERHEAT SWITCH
Remove the two screws holding the switch to the
top left front of the sheetmetal surround.
Disconnect the wire from the switch and remove the
switch.
3.4 ADJUSTMENTS AND
REPLACEMENT PARTS
Adjustments and replacement parts for this appliance
should only be done by a qualified service person. A
wiring diagram for the appliance is shown in
SECTION
2.0 OPERATING INSTRUCTIONS
. A replacement part
table is shown in
SECTION 4.0
of this manual.
FIGURE 30
TENSION
SPRING LATCH
LATCH BRACKET
GLASS ASSEMBLY
