20
35020 Rev G
06-03
BCBR36 B-VENT GAS APPLIANCE
4. High Limit Safety Switch
This appliance is equipped with an auto reset high limit
switch which will shut down the appliance if it becomes
too hot. If this happens, turn the appliance off and shut
off the gas supply. Do not attempt to operate the
appliance until it has been examined by a qualified
service technician. See Figure 25 for limit switch
location.
WARNING!
Gas appliances equipped with doors should be op-
erated only with doors fully open or doors fully
closed. If doors are left partially open, gas and flame
may be drawn out of the firebox opening, creating
risks of both fire and spillage.
Note:
When cleaning the glass, NEVER use
abrasive materials. NEVER clean glass when it
is hot. Keep pets and children a safe distance
away.
5. Glass Breakage/Cleaning
It is recommended to wear gloves while handling or
removing glass.
DO NOT REMOVE GLASS WHEN
IT IS HOT!
a.
Clean glass after initial 4-6 hours burning time.
This is to remove any film that develops from oils
and log burn. After initial cleaning, clean as
needed.
b.
Handle glass panel with care to avoid striking or
scratching it on hard objects.
c.
To clean the glass, use a nonabrasive, mild
cleaning solution (i.e. Brasso). Apply an adequate
amount to the glass and wipe off per
manufacturers instructions. Contact your local
stove shop or fireplace accessories store for
further recommendations.
d.
In the event of glass breakage, carefully remove
the glass frame. This will allow the removal of all
glass fragments and sheet metal edge protection
strips. Vacuum all remaining glass pieces with a
shop vac.
DO NOT VACUUM IF PIECES ARE
HOT!
Replace glass doors only with a Hearth &
Home Technologies glass door assembly ordered
through your local distributor/dealer. Never use
substitute material. Only fully tempered soda lime
safety glass may be used on this appliance.
Figure 25 - Limit Switch Location
