3
ANTENNA
LEARNING
BUTTON
SLIDE
SWITCH
OFF
REMOTE
ON
The remote receiver has a 3-position slide switch: OFF/
REMOTE/ON (see Figure 3).
Figure 3. Remote Receiver
Choosing Remote Control or Thermostatic Opera-
tion (with a wall thermostat wired in series)
To operate appliance with a WALL THERMOSTAT only:
The slide switch on the remote receiver must be in
the ON position. To operate the system by remote
control again, return the slide switch on the remote
receiver to the REMOTE position and set the wall
thermostat ON or at a high-heat setting.
NOTE: The remote receiver will only respond to
the transmitter when the 3-position slide button on
the remote receiver is in the Remote position. If
the system does not respond to the transmitter on
initial use, see section Matching Security Codes.
1. With the slide switch in the ON position, the system
is on.
2. With the slide switch in the REMOTE position, the
system only operates if the remote receiver receives
commands from the transmitter.
3. With the slide switch in the OFF position, the system
is off.
NOTE:
The slide switch should be placed in the OFF
position if you will be away from your home for an ex-
tended period of time. Placing the switch in the OFF
position also functions as a safety “lock out” by turning
the system off and rendering the remote receiver inop-
erative.
TRANSMITTER
Important: Before operating remote control, trans-
mitter and receiver must have matching security
codes. See section ‘Matching Security Codes’.
Important:
Review Communication-Safety Features’
under ‘Transmitter Safety Features’ section. This safety
feature shuts down the fireplace system when a poten-
tially unsafe condition exists.
Important:
Review ‘Auto Shutdown’ section. This
safety feature shuts down the fireplace after 9 hours of
continuous operation, in ON mode only.
Important:
New or fully charged batteries are essen-
tial for proper operation of the multi-function transmit-
ter. The transmitter operates on 2 AAA-size 1.5V bat-
teries. Use Alkaline batteries for longer battery life and
maximum operational performance.
Insert 2 AAA-size 1.5V batteries into the battery com-
partment on the back of the transmitter. When the bat-
teries are correctly inserted, the screen will display
numbers (see Figure 4 for LCD Display Screen).
Figure 4. Transmitter LCD Display Screen
1.
ROOM TEMP
- Current room temperature.
2.
0
F
- Degrees Fahrenheit (
0
C indicates degrees Celsius).
3.
FLAME
- Indicates burner/valve operational.
4.
LOW
- Battery power low. Replace batteries within two weeks.
LCD DISPLAY SCREEN
TRANSMITTER
f i r e - p a r t s . c o m
