Hearth & Home Technologies • RC150 IntelliFire
™
Touch Installation Instructions • 2326-980 • 9/16
4
D. Power Outage
In the event of a power outage, the IFT-RC150 can
continue to operate the hearth appliance if batteries are
installed in the appliance’s battery backup system. Refer
to the appliance Owner’s Manual for instructions for
operation during a power outage.
E. Manual Appliance Shutoff
In the unlikely event that the IFT-RC150 malfunctions and
will not turn off the appliance, call your dealer for service
assistance. In the meantime, you may choose one of the
following actions to turn off the appliance:
CAUTION! Risk of burns! Appliance surfaces are hot
when operating and during cool down. Use care and wear
gloves when opening the front and accessing compo-
nents inside the appliance.
Turn off power to the appliance (if back-up batteries
are not installed):
• If the appliance comes equipped with a wired-wall switch,
use that to turn it off.
•
Alternately, you can also locate the house circuit breaker
for appliance and turn it off.
NOTICE: Batteries should only be used as an appliance
power source in the event of a power outage. Batteries
should not be used as a primary long-term power source.
A. Turn Flame ON/OFF
• To turn the flame ON, press the top of the rocker switch.
• To turn the flame OFF, press the bottom of the rocker
switch.
The IFT-ECM on the appliance has a safety feature that
automatically shuts down the appliance after 9 hours of
continuous operation without receiving a command from
any of its paired devices.
Figure 6. IFT-RC150 Functions
B. COLD CLIMATE
This function turns on a continuous pilot and keeps the air
inside the hearth appliance warm while not in use. It is a
useful feature in cold weather to minimize condensation
on the appliance glass.
• To turn the cold climate mode ON/OFF, press the small
momentary push button below the rocker switch.
C. LED INDICATOR
• The LED indicator is located above the rocker switch. It
blinks every time it transmits a function and also during
pairing.
• The LED also functions as a IFT-RC150 low battery
indicator. Replace batteries if the red LED blinks once
every 3 seconds continuously for longer than 5 minutes.
Note:
If the LED blinks once every 2 seconds for 2 minutes,
every 12 minutes, this indicates that the IFT-RC150
has lost communication with IFT-ECM.
3. Operation
RED LED
COLD CLIMATE ON/OFF
FLAME ON
FLAME OFF
