Hearth & Home Technologies • RC150 IntelliFire
™
Touch Installation Instructions • 2326-980 • 9/16
2
Figure 3. Mounting IFT-RC150 Wireless Wall Switch
Figure 4. Pairing IFT-ECM and IFT-RC150
REMOTE POSITION
PAIRING HOLE
GREEN LED
PAIRING HOLE
5. Secure the wall switch on a flat wall surface using the
two screws and drywall anchors provided. See Figure
3.
6. Insert the two AA batteries (supplied) in the correct
orientation as marked in the battery receptacle. See
Figure 3.
Figure 2. Wall Switch Disassembly
4. Insert small flat screwdriver in the tab located in the
bottom of the wall switch and twist the screwdriver to
disassemble the wall switch. See Figure 2.
E. Pairing the IFT-RC150 to the Electronic Con-
trol Module (IFT-ECM)
CAUTION! Risk of burns! DO NOT program the IFT
Remote Controls to the IFT-ECM when flame or cold
climate function is on or when appliance is hot.
1. ON the IFT-RC150, remove the cover as shown in
Figure 2 to access the pairing hole as shown in Figure
3.
2. On the IFT-ECM, move the ON/OFF/REMOTE switch to
the REMOTE position. The green LED will blink three
times. A few seconds later, an audible “beep” will occur
to indicate that the system is ready.
Note:
If the green LED continues to blink slowly (system
is searching for a clear channel), wait until it stops before
proceeding to step 3.
3. Locate the pairing hole on the IFT-ECM. See Figure 4.
Using a paper clip or similar item, press and release
the pairing button. The IFT-ECM will “beep” once and
a green LED will blink for 14 seconds.
While the green LED on the IFT-ECM is blinking, press and
release the pairing button on the IFT-RC150 with a paper
clip or similar item. The device will indicate it is in pairing
mode by blinking red LED. If the device has been paired
successfully to the IFT-ECM, an audible double “beep” will
be heard from the IFT-ECM.
4. If pairing is unsuccessful, repeat step 3.
5. Replace IFT-RC150 cover removed in step 1.
NOTICE: To program both an IFT-RC400 and an IFT-
RC150 to an IFT-ECM, repeat the same steps separately
for the IFT-RC400 and the IFT-RC150. Only one IFT-RC400
remote control and one IFT-RC150 wireless wall switch can
be programmed into an IFT-ECM.
