1
Hearth & Home Technologies • AMB-LIGHTS Installation Instructions • 2273-934 Rev. B • 9/14
AMB-LIGHTS
Models: FRAME-V12, FRAME-S21, FRAME-H31
STUDIO-V12, STUDIO-S21, STUDIO-H31, DF-FSV7, DF-FSS7, DF-FSH7
Installation Instructions
Leave this instruction with party responsible for
use and operation.
CAUTION! Do not install damaged components.
If
you received components that are damaged, contact
your dealer for assistance.
WARNING
This appliance has been supplied with an integral barrier
to prevent direct contact with the
fi
xed glass panel. Do
NOT operate the appliance with the barrier removed.
Contact your dealer or Hearth & Home Technologies if the
barrier is not present or help is needed to properly install one.
HOT SURFACES
!
Glass and other surfaces are hot during
operation AND cool down.
Hot glass will cause burns.
• Do not touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room as
fi
replace.
• Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other
fl
ammable materials.
• Keep clothing, furniture, draperies and other
fl
ammable
materials away.
CAUTION! Risk of Cuts or Abrasions.
Wear protective
gloves and safety glasses during installation. Sheet metal
edges are sharp.
KIT CONTENTS:
• LED 12 Volt Power Supply
• Wire Clip, 1/4 in. diameter (10)
• Wire Tie, 6 in. (10)
• LED Switch Box
• 1 X 1 Velcro Assembly (3)
• Nut, Keps #10-32 (4)
• LED Strips/Wire Assembly
• Extension Wire (Optional)
• LED Brackets (2)
INSTALLATION
1. All steps to install the AMB-LIGHTS Kit will be done on the
lower back side of the decorative front. Figure 1 shows
the features used to determine the top and bottom of the
decorative front.
2. Place the LED switch box on the lower stud of the deco-
rative front. See Figure 2. For top mounting of the LED
switch bracket, see page 3.
Note:
Exact position of LED switch box may vary depend-
ing on appliance model.
3. Place LED brackets onto top and bottom studs. The bot-
tom of the LED bracket will share the stud with the LED
switch box and the 12V power supply ground. See Figure
2, Figure 3 and Figure 8. Bend LED brackets to achieve
the desired angle for light distribution. A 45 degree angle
may achieve the optimum lighting effect. The brackets
will be secured with keps nuts in Step 9.
Note:
The AMB-LIGHTS kit is not approved for use with
the Radius door.
Figure 2. View from Back Side of Decorative Front
(H31 Decorative Front Shown)
LOWER
LOWER
STUD
STUD
LED
LED
SWITCH
SWITCH
BOX
BOX
LED BRACKET
LED BRACKET
STANDOFF LOCATED AT TOP OF DOOR
2 CLIPS LOCATED AT BOTTOM OF DOOR
THIS END UP
Figure 1. Decorative Front - Rear View
Note: Tab is oriented
Note: Tab is oriented
toward outside of
toward outside of
decorative front.
decorative front.
