2
Hearth & Home Technologies • AMB-LIGHTS Installation Instructions • 2273-934 Rev. B • 9/14
6 IN. MINIMUM
6 IN. MINIMUM
6. Connect the yellow and black 12V power supply wires to
the red and black wires from the LED switch box. See
Figure 4 and Figure 7.
7. Connect the LED switch box to the LED strips/wire as-
sembly. See Figure 4 and Figure 7.
8. Position the 12 volt power supply box at least six inches
from the outer edge of the door to allow for clearance
for the outer wrap. Secure with velcro piece(s). The
12 volt power supply should rest on the bottom return
bend of the door. See Figure 5.
9. Secure the ground wire from the 12V power supply.
The ground terminal should come into contact with
the unpainted portion of the LED switch box. See Fig-
ure 8. Secure top and bottom studs with keps nuts.
Figure 3. LED Strips Installed with Zip Ties
LED STRIP
LED STRIP
POSITIONED
POSITIONED
ON LED
ON LED
BRACKET
BRACKET
ZIP TIES
ZIP TIES
CONNECT WIRES HERE
CONNECT WIRES HERE
Figure 4.
STEP 7
STEP 7
STEP 6
STEP 6
Figure 5.
WIRE CLIPS
WIRE CLIPS
WIRE CLIPS
WIRE CLIPS
TOP STUD
TOP STUD
12V POWER
12V POWER
SUPPLY
SUPPLY
4. Remove the adhesive backing from the LED strips and
adhere the LED strips in place on the LED brackets. See
Figure 3.
5. Secure each LED Strip with
fi
ve zip ties. Place zip ties in
the “white” areas of the LED strips. Do not allow zip ties
to cover the light emitters on the LED strips. Trim ends of
zip ties. See Figure 3.
Note:
Only four of the
fi
ve zip ties
are visible.
LOWER
LOWER
STUD
STUD
10. Wrap excess wire neatly using the provided plastic clips.
Keep it away from the mesh area and secure it tight to
the door. See Figure 3 and Figure 5.
