Hearth & Home Technologies • CK-30 Cabinet Kit Installation Manual • 4126-900 Rev A • 07/22
27
21. Install the top of the CK-30 cabinet by setting on top of
the cabinet upper sides and cabinet upper back using 7
screws. See Figure 6.21.
,_
,_
,_
Figure 6.21
23. Install the INFIT-30-BK front on the insert. Adjust the
insert from side to side and front to back to make sure
the inside fit front is level prior to attaching the venting.
See Figure 6.22.
24. Install the trim ring around the collar by setting in place
on top of the CK-30 cabinet. See Figure 6.23.
Trim Ring
Figure 6.23
20. Connect the 1/4” insulated female connectors from wire
(30007499) to the on/off switch. See Figure 6.20.
Figure 6.20
22. Refer to EXCURSION-II, RUBY30IN, RUBY30IL,
SUPREME-I30-IFT, SUPREME-I30-BIR, SUPRM-
I30LP-IFT Insert Installation manual for instructions on
how to set up the burner and logs for the gas insert.
B. Securing and Leveling the Appliance
WARNING! Risk of FIre!
Prevent contact with combustible
materials.
WARNING! Risk of FIre!
Failure to maintain air space
clearance may cause overheating and fire.
1. Level the CK-30 cabinet from side to side and front to
back.
2. Shim the CK-30 cabinet as necessary. It is acceptable to
use wood shims underneath the CK-30 cabinet.
3. For mobile home installations, secure the CK-30 cabinet
to the floor using screws through the holes in the bottom
of the cabinet. See Figure 6.24.
Screw locations
Figure 6.24
Figure 6.22
