Do not store the unit in direct sunlight, high temperature or humidity. Keep the unit out of small children.
Always keep the unit unplugged while not in use.
Cleaning Cautions
Check the medication cup and air filter before each use. Dirty or wom parts should be replaced. Do not
immerse the unit in water. It may damage the unit. Disconnect the unit form the electrical outlet before
cleaning. Clean all necessary parts after each use as instructed in this guidebook.
Cleaning Procedures
It is important to clean your Ultrasonic Nebulizer before the first time it is used and after each use.
Remember: Disconnect the unit from the electrical outlet and never immerse the unit in water.
Cleaning the parts:
The extension tube, mask, top cover, medication cup, filter holder and air filter should be cleaned with a mild
detergent or commercially available disinfectant. Thoroughly rinse each part and allow to completely air dry
before using.
Cleaning the main unit:
The main unit should be cleaned with a soft cloth moistened with a non-abrasive cleanser and water.
Operating Your Nebulizer
Follow the previous cleaning instructions prior to using your Ultrasonic Nebulizer for the first time or after it
has been stored for an extended period. Remember: Always disconnect the main unit from the electrical
outlet before cleaning and filing and after each use.
To fill the water tank,
Fig.1
1.Remove the top cover by pulling straight up, fig.1. Remove the medication cup if applicable.
Fig.2
2.Select either tap or distilled water* that has a temperature range of 20ºC-30ºC, fig.2
*Distilled water is preferred.
Fig.3
3.Fill the water tank with tap or distilled water to the indicated level (between the 2 lines located inside the
water tank), fig.3
Remember: Do not use solutions other than water in the tank. It may damage the transducer- Fill to the
correct level.
Note:
-The use of cool water( below 20ºC) will result in a lower rate of nebulization.
-The use of warm water (above 30ºC) will result in a higher rate of nebulization.
To fill the medication cup
1.Place the medication cup inside the water tank.
2.Pour the medicine directly into the medication cup.
3.Replace the top cover.
Remember:
The maximum capacity of the medicine cup is 4.5ml, and should not be overfilled. Dilute dense medications
or medication volumes 2ml, or less with distilled water or saline solution to obtain a volume of at least 4ml.
Only use medications under the instructions of your physician.
Fig.4
To connect the AC adapter
1.Insert
the adapter plug into the unit’s AC port, fig.4
2.Plug the adapter into a standard AC outlet.
