Healthrider H125t Treadmill, User Manual

Page: 7 / 36

7
3. Identify the Left Upright (88), which is marked
“Left.” Have a second person hold the Left
Upright near the Base (91).
See the inset drawing. Tie the wire tie in the
Left Upright (88) securely around the Upright
Wire (77) about 8 in. (20 cm) down from the end.
Then, pull the other end of the wire tie until the
Upright Wire is routed through the Left Upright.
Note: The Upright Wire should bend so that the
connectors are pointing downward.
1. Make sure that the power cord is unplugged.
Place a piece of cardboard below the rear of the
Frame (57) to protect the floor or carpet.
Attach the Left Wheel Cap (92) to the Base (91)
with two #8 x 3/4" Screws (2).
Attach the Right Wheel Cap (not shown) to
the right side of the Base (91) in the same
way.
1
92
91
2
57
Cardboard
2. Pull the Upright Wire (77) and the ground wire
(A) through the indicated hole in the Base (91).
Attach the ground wire (A) to the Base (91) with
a #8 x 1/2" Ground Screw (10).
Press the Grommet (75) into the square hole in
the Base (91).
77
2
91
75
Hole
10
A
77
3
77
88
Wire
Tie
88
91
77
Wire Tie