Healthrider H125t Treadmill, User Manual

Page: 10 / 36

10
Console
Assembly
Pulse
Wires
88
9
77
77
Console
Wire
10. Set the console assembly on the brackets on
the Left and Right Uprights (88, not shown). Be
careful not to pinch any wires.
Attach the console assembly with four 5/16" x
1 1/4" Screws (4) and four 5/16" Star Washers
(11) (only one side is shown). Start all four
Screws, and then tighten them.
Tighten the four 3/8" x 4 1/2" Screws (5) (only
one side is shown).
Insert the excess wires into the hole in the con-
sole assembly. Tighten the ties around the wires
and cut off the ends of the ties.
10
Console
Assembly
11
4
88
5
Bracket
Console
Wire
Ties
Ties
Hole
9. With the help of a second person, hold the con-
sole assembly near the Left Upright (88).
Route the Upright Wire (77) and the pulse wire
from the Left Upright (88) around the indi-
cated crossbar. Then, route the wires through
the looped ties on the bottom of the console
assembly.
Connect the Upright Wire (77) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
Connect the pulse wire in the console assembly
to the pulse wire in the Left Upright (88).
Crossbar