14
Turn on the console.
See step 1 on page 13.
Select one of the five preset programs.
Each time the
console is turned
on, the manual
mode will be
selected. To
select a preset
program, press
the Program but-
ton repeatedly until the number 1, 2, 3, 4, or 5
appears in the upper right corner of the display.
The profiles numbered 1 through 5 on the left
side of the console show the resistance and pace
settings for the preset programs.
Start the program.
To start the program, simply begin pedalling.
Each preset program consists of either 20 or 30
one-minute periods. One resistance setting and
one pace setting are programmed for each peri-
od. (The same resistance setting and/or pace set-
ting may be programmed for consecutive peri-
ods.)
During the program, the resistance of the elliptical
crosstrainer will automatically change as shown
by the applicable profile on the console. Note: If
the current resistance level is too high or too low,
you can change the resistance level by pressing
the + or – button. However, when the current peri-
od of the program is completed, the resistance
level will automatically change if a different resis-
tance setting is programmed for the next period.
The target pace
settings for the
program will be
shown by the
right pace indica-
tor in the display.
(The left indicator
will show your
actual pedalling pace.) As the right indicator
changes in height during the program, adjust your
pace so that both indicators are the same height.
If your pace is slower than the current target
pace, the increase arrow will appear in the dis-
play to prompt you to increase your pace; if your
pace is faster than the target pace, the decrease
arrow will appear.
Important: The pace settings
for the program are intended only to provide a
goal. Your actual pace may be slower than the
pace settings, especially during the first few
months of your exercise program. Make sure
to pedal at a pace that is comfortable for you.
During the program, the display will show the time
remaining in the program. When no time remains,
the program will be completed. If you continue
pedalling after the program is completed, the dis-
play will continue to show your exercise feedback.
Follow your progress with the feedback modes.
See step 4 on page 13.
Measure your heart rate if desired.
See step 5 on page 13.
When you are finished exercising, the console
will automatically turn off.
See step 6 on page 13.
6
5
4
3
2
1
HOW TO USE A PRESET PROGRAM
Increase Arrow
