6
1.
Attach a Wheel (8) to one side of the Frame (1)
with an M10 x 35mm Patch Screw (57).
Attach
the other Wheel (not shown) in the same
way.
2. Apply a generous amount of the included
grease to the Pivot Axle (41). Then, insert the
Pivot Axle through the Frame (1).
Apply a small amount of grease to a 16mm
Wave Washer (66). Slide the Wave Washer
onto the right side of the Pivot Axle (41).
Identify the Right Upper Body Arm (37), which is
marked with a sticker. Slide the Right Upper
Body Arm onto the Pivot Axle (41). Attach the
Right Upper Body Arm with an M8 x 25mm
Patch Screw (77), a Pivot Axle Cover (44), and
an M8 x 25mm Washer (54).
Attach the Left Upper Body Arm (23) in the
same way.
1
2
66
57
1
8
37
23
41
Grease
1
44
77
54
3. Orient the Water Bottle Holder (6) as shown.
Hold the Water Bottle Holder near the Frame
(1) and insert the Wire Harness (73) upward
through the Water Bottle Holder.
Next, slide the Water Bottle Holder (6) onto the
Frame (1). Attach the Water Bottle Holder with
two M4 x 35mm Screws (74).
3
1
73
6
74
To make assembly easier, read the
information on page 5 before you begin
assembling the elliptical exerciser.