Page
16
of
24
4/24/2018
5.
Once the device has reached the end of the area you are inspecting, retract the
scope slowly while looking for debris or damage.
Verifying Operation
Following the steps listed below will ensure the proper use and performance of the
Flexible Inspection Scope. This is recommended to confirm the operation of the
scope the scope’s operation needs to be checked.
WARNING: The minimum bend radius of the Flexible Inspection Scope
is 0.85in. Do not bend the Flexible Inspection Scope into a sharper bend
or damage to the device could occur.
IMAGE
1.
Open the Flexible Inspection Scope Viewer software on your computer.
An image from the camera should appear on your computer monitor.
2.
If the image does not appear true white when the camera is pointed at a
white object (FIGURE X), direct the Distal Camera
toward a solid white object such as a blank white
sheet of paper. Press the White Balance (WB)
Button on the Flexible Inspection Scope and release
when the image on your monitor appears white.
ILLUMINATION
1.
The illumination capability of the Flexible Inspection Scope can be
verified prior to use. Once the scope is connected to your computer with
the power on, the distal tip of the Flexible Inspection Scope will cast
visible light from its tip and can be observed on any surface to which it is
directed
2.
The Flexible Inspection Scope will default to the minimum light intensity
setting when started. To adjust the lighting, press (in increments or hold)
the Brightness Increase (+) Button or the Brightness Decrease (-) Button
on the Digital Inspection Scope.
Instructions for Cleaning and Disinfecting or Sterilizing
WARNING: The Flexible Inspection Scope is provided non-sterile.
Before initial use and after each use, the external surfaces of the Flexible
Inspection Scope should be cleaned.
WARNING: Place the Soaking Cap on the Camera Connector prior to
soaking or steaming the Flexible Inspection Scope. Repeated exposure to
fluids will corrode the contacts of the Camera Connector.
PREPARATION FOR CLEANING THE FLEXIBLE INSPECTION SCOPE
The Flexible Inspection Scope has fluid ingress protection rating of IPX7 and can
withstand immersion in fluid up to 1 meter for up to 30 minutes.
