English
DELIVERY CONTENTS / CRESCENT GRAB BAR
FIGURE A.
1. Rail (Crescent Grab Bar)
2. #10 x 1.75" Wood Screw, S/S (x6)
INSTALLATION WARNINGS
FIGURE B.
1. Rail must be installed to walls that are structurally sound.
2. If desired installation location does not have adequate structure, add
wood blocking.
3. CAUTION - Do not install if there is no structure behind drywall.4. To
reinforce hollow walls, we recommend Easy-Mount Anchors (each sold
separately). Weight capacity 300lbs.
5. CAUTION - Do not install if structure behind walls is unknown.
6. CAUTION - Do not install into metal studs.
7a. CAUTION - Do not install in fiberglass / acrylic shower enclosures with
insufficient stiffness and strength.
7b. Add wood blocking if required.
SUGGESTED CRESCENT GRAB BAR LOCATIONS
FIGURE C.
Align the notch on the flange with the center of vertical studs. To
determine the optimal mounting location, we recomment holding the rail in
place and walking through the motions of a transfer (sitting, standing,
reaching, etc.). Recommended rail height 36-48" / 914-1219mm. For entry
into bathtub (flanges horizontally aligned), we recommend rail height
48-60" / 1219-1524mm.
INSTALLATION
FIGURE
D.
1. Hold the rail against the wall and adjust with level. Using the flanges as
a locating guide, mark the screw hole locations.
2. Drill pilot holes for fasteners.
3. Fasten the rail to the wall using appropriate fasteners and
waterproofing.
4. Slide flange cover over flange to conceal screws. Inspect hardware
regularly, and tighten if required.
TECHNICAL DATA
See Figure E.
PRODUCT USAGE
FIGURE F.
CAUTION - Rail and bathtub are slippery when wet.
Gate 88
Kanalgatan 45B
Skellefteå, Sweden
93123
6
OVERVIEW
Thank you for choosing the PLUS Crescent Grab Bar. Please read and
understand the instructions in this manual; keep manual for future
reference. It is your responsibility to see that your PLUS Crescent Grab Bar
is properly assembled, installed, and cared for. Failure to follow instructions
in this manual could result in serious injury or death. If you are not
equipped to undertake the outlined work, we would recommend that you
have your PLUS Crescent Grab Bar installed by a qualified contractor.
The PLUS Crescent Grab Bar is a curved grab bar and toilet roll holder,
designed to disguise safety in a bathroom accessory. The PLUS Crescent
Grab Bar is intended for moderate vertical and horizontal load bearing to
provide sitting and standing support for people with reduced mobility. The
PLUS Crescent Grab Bar is installed with appropriate fasteners to a
structural wall. The maximum user weight for this product is 500lbs /
227kgs. Note: Product is not intended to support full body weight. The
PLUS Crescent Grab Bar is not to be used in any other way than described
above.
LIMITED LIFETIME WARRANTY
Products are covered by a limited lifetime warranty against defects in
materials and workmanship for the original purchaser. Warranty excludes
products that have been damaged through misuse, accidental damage,
alteration, normal wear and tear, wood material and stain, or the use of
corrosive or abrasive cleaning products.
Buyer hereby indemnifies, agrees to hold harmless and defend HealthCraft
Products Inc. from and against any and all liabilities, claims, (founded and
unfounded), losses, damages, costs and expenses (including without
limitation consequential damages and reasonable professional fees)
resulting from buyers specification, application, or improper use of goods
described hereon; buyers omission or neglect. HealthCraft Products Inc.
does not assume any liability for damage resulting from services performed
by others or faulty installation, misuse or misapplication of goods sold by
HealthCraft Products Inc. HealthCraft Products Inc. shall not be liable for
prospective profits or special, indirect, or consequential damages, or for the
cost of any corrective work done without HealthCraft Products Inc. prior
approval. HealthCraft Products Inc. total liability hereunder shall in no
event exceed the purchase price of the goods specified hereon.
Specifications subject to change without notice.
HealthCraft Products Inc.
2790 Fenton Road
Ottawa, Canada
K1T 3T7
EC
REP
