Health O Meter PROPLUS 2500KGWA, User Instructions

Page: 10 / 236

9
2600KGWA ASSEMBLY (CONTINUED)
Ramp Instructions
:
Follow these instructions for moving the ramp to the opposite side of the scale or for adding a second
ramp to the scale (2600RAMP option), to have ramps on both sides of the platform:
1. Remove guardrail (A) at the end of the platform by unscrewing 4 screws (B)--see
Figure 5
, below.
2. Fold the ramp on the platform surface.
3. Gently tip the scale over and place it with the handrail on the floor.
4. Remove the screws attaching 2 rubber bumpers (C) on the side of the platform under the ramp
attachment. Remove the bumpers. Install the rubber bumpers on the opposite platform side in the
appropriate holes.
5. Remove 4 screws at each ramp holder (D)--2 screws at ramp side and 2 screws at the bottom of the
ramp, close to wheel.
6. Remove the ramp from the ramp holders, then release all the screws to the end and remove ramp
holders by pulling out slightly.
7. Install ramp holders in the same way at the opposite side of the platform, do not tighten screws.
8. Insert the ramp between ramp holders and tighten screws.
9. Install the guardrail by screwing 4 screws (B). Note : It is necessary to bore a hole in the mat to insert
the screw in appropriate hole beneath the mat.
Figure 5
NOTE: A second ramp is available separately as 2600RAMP.