Health O Meter 2400KL, User Instructions

Page: 14 / 24

14
SETUP / BATTERIES / TRANSPORT
Preparing the 2400KL Scale for Use
1. Remove the protective plastic film covering the display (the film says “FACTORY
CALIBRATED”).
2. Place batteries into the battery holder (see Figure 11).
3. Plug the scale’s AC adapter into the power source.
4. Ensure all objects are removed from the scale’s assembly, and then press the ON/OFF
button to turn the scale on. The display will show “Start”, then “0.0LB” or “0.0KG”. Press the
UNIT button to select the weight mode (lb or kg).
Note
: This scale will always default to the settings and units last used (lb or kg).
5. When the AC adapter is disconnected from the scale, the scale will switch to battery power if
batteries are installed.
Note : If the set up procedure failed, refer to the troubleshooting instructions. If the problem is
not corrected, refer to qualified service personnel.
Replacing / Inserting Batteries
1. Unplug the AC adapter from the power source.
2. Remove the battery cover on the side of the display assembly by unscrewing the (2) battery
cover screws (see Figure 11).
3. Replace or install the batteries with new units. Health o meter recommends using an alkaline
or lithium battery, rated for 130°F (54°C) operation. Do not use zinc-carbon batteries.
4. Re-attach the battery cover to the display assembly.
Warning: If the scale will not be used for some time, remove the batteries to avoid a
safety hazard. Disposal of batteries must be performed in accordance with the prevailing
national, regional or local regulations which apply to you
.