Health in motion INSPIRE, Assembly & Operation Manual

Page: 17 / 34

Page 14
Step 16: First, slide the Shim Washer onto the shaft against the bearing, then insert the Rectangular Key
into the slot in the Shaft as shown. Loosen the Cap Screws on the Shaft Collar so that the
Selector Plate can slide over the Shaft of the Left Pivot Arm. Align the keyway in the Shaft Collar
with the rectangular key and push the Selector Plate against the Shim Washer. Slide Wave
Washer onto Shaft, then the Left Arm Assembly. Attach the Aluminum Endcap to the shaft with
the M10 x 20 Flat Head Screw. Finally, reattach the bottom half of the Shaft Collar with the M6
Cap Screws. Tighten both screws evenly and tightly. There will be a small gap between the two
halves of the Shaft Collar when fully tightened.
1 - M10 x 20 Flat Head Screw
1 - Aluminum Endcap
1 - Rectangular Key
1 - Wave Washers
1 - Shim Washer
NOTE: Wrench Tighten Now. 2 – M8 Cap Screws
1 - M10 x 20 Flat Head Screw
1 - Aluminum Endcap
1 - Rectangular Key
1- Wave Washer
1 - Shim Washer
2 – M8 Cap Screws
Step 16
Left Pivot Handle
Left Pivot Arm
Rectangular Key
Shim
Washer
Wave
Washer
Selector Plate
Shaft Collar
Cap Screws
Keyway in
Shaft Collar
Left Arm
Assembly