INSTALLATION
INSTRUCTIONS
Model SP-SI
"Innovative Products for Independent Living"
TM/MC
SuperPole
TM
Safety Island
TM
CAUTION
RISK OF INJURY!
Understand these instructions prior to using product.
Also, refer to the SuperPole
TM
System instructions.
HealthCraft Products Inc., 2790 Fenton Rd., Ottawa, Ontario, Canada, K1T 3T7
Copyright 2004. Specifications subject to change without notice.
Prior to installing the Safety Island
TM
option, we strongly
recommend that you first read through these instructions.
We would also recommend that you set aside a space on
the floor or a table to prepare the SuperPole
TM
System prior
to raising the pole for final installation.
D1.
See steps A1 and A2 on page 2. Complete these
instructions and then continue with step D2.
D2.
Unpack the Safety Island
TM
unit (27). Slide the Safety
Island
TM
unit (27) onto the pole assembly (2) as shown in
Figure D1 (side of tray on top of spokes to go onto pole
first). Slide it on as straight as possible to avoid scratching
the paint on the pole.
D3.
See steps A3, A4, and A5 on page 2. Complete these
instructions and then continue with step D4.
D4.
The next step is to fix the Safety Island
TM
to the pole as
shown in Figure D2. It is recommended that the tubular ring
of the Safety Island
TM
is approximately 28" - 36" from the
floor (this height is determined by the height of the user -
consult your therapist).
Fasten the Safety Island
TM
to the pole by installing and
tightening the three set screws (28) with the provided hex
key wrench (29). You will need to slide the spring ring (30)
downwards to gain access to the screw holes.
IMPORTANT
- These screws MUST be tightened until they
are flush with the collar or injury may result. NOTE: By
tightening the set screws, the cone points will penentrate
the pole for positive engagement, thereby leaving
permanent indentations in the pole. BE CERTAIN THE
SAFETY ISLAND
TM
IS AT THE CORRECT HEIGHT AND
ORIENTATION BEFORE PROCEEDING.
D5.
Slide the spring collar upwards on the Safety Island
TM
collar as shown (Figure D3) to retain the set screws (28)
while in service. Inspect frequently to ensure screws and
collar are tight.
D6.
See steps A2 to A9 on page 2. Complete these
instructions to finish the installation of your Safety Island
TM
.
FIGURE D1
2
27
SLIDE ONTO POLE
FIGURE D2
D1
INCORRECT!
CORRECT!
Ensure all three set screws
are screwed in completely
until back end of screw is
flush as shown.
TUBULAR RING
HEIGHT RANGE
FROM FLOOR
28"-36"
SET HEIGHT AND TIGHTEN SCREWS
FIGURE D3
Slide the spring collar
upwards over as shown
to retain the screws whle
in service.
INSTALL SPRING COLLAR
28
29
30
