- 2 -
3. Setting and Using your SH
3.1
Preparation
1.
Ensure that the unit is installed correctly by executing the SH Test instructions
(Refer to chapter 3.7)
.
2.
Determine the Calibration value needed for your application. Use the online
calculator on our website or download the SpeedoHealer calculator app.
(For calculation formula, refer to chapter 4).
3.
Turn ignition ON.
3.2 Programming a calibration value
Entering into programming mode does not clear the previous setting, so you
can update a previously stored calibration value easily.
All settings are stored in Flash memory. No need to repeat programming after
the battery or the SH box has been disconnected.
1.
Press
BOTH buttons
on the unit until [
L
] is indicated.
2.
The Sign of the calibration value is blinking:
[
-
] : Negative
[
P
] : Positive
To toggle the Sign, press the
SET
button.
If the Sign you set is Negative, you will program 3 digits (max value: 99.9)
If Positive sign was selected, you need to enter 5 digits (max value: 9999.9)
You need to enter all digits (including the leading zeros), e.g. enter -07.5 if
you want to program -7.5%
3.
Press
SEL
to proceed to the first digit of the calibration value.
[
n
] (next) is shown, and then the value of the first digit will blink.
Press
SET
repeatedly until the desired value is shown.
Repeat this step until all digits are entered.
4.
After the last digit has been entered, press
SEL
to exit from programming mode.
[
o
] (over) is shown, and then the unit will display the programmed digits in
order, just like any time ignition is turned ON.
3.3 Reviewing the calibration value in use
Whenever the ignition key is turned ON, the unit will show the following
information in order:
- Memory bank in use: either [
A
] or [
b
]
- Sign of the Calibration value: [
-
]: Negative, [
P
]: Positive
- Calibration value without leading zeros
- Conversion mode active [
C
] or not (blank)
Examples:
[
A 0
] means memory bank A is active with no calibration (factory default)
[
A - 7. 5
] means memory bank A is active with -7.5% calibration
[
A – 1 2. 5 C
] bank A is in use with -12.5% and Km/h conversion is enabled
[
A P 5. 0
] means memory bank A is active with +5.0% calibration
[
b P 6 2 3 4. 5 C
] bank B, +6234.5% and Km/h conversion is enabled
