8
1.1.3 SHOCKS WARNING
Immediately stop the use of any Mains powered or Mains connected
gear when even minor shocks are detected and seek a practical
consultation from a qualified professional electronics repair technician
or relevant approved Authorised Service Centre before using again.
1.1.4 PREVENTION OF SHOCKS & DAMAGE
DO NOT expose the EDB-2, its Power Supply Unit or attached cables
to any liquids such as rain, condensation/spilt drinks.
If your EDB-2 should become in contact with any water or other liquids,
switch off at mains power socket and disconnect. Make sure it is fully
dry and dry your hands before re-use.
1.1.5 VENUE WARNING
Avoid venues with suspect electrical wiring, damp or wet wires &
contacts or where sparks are visible.
1.1.6 MICROPHONE SAFETY WARNING
Where microphones are used into EDB-2 or PA system, try to use
Government Type approved & Licensed Radio Mic’s and Transmitters.
1.1.7 CABLE & PRE-AMP PLACEMENT WARNING
Place EDB-2 and cables where visible and cannot cause accidents,
e.g. on a table, Mic stand or Belt mounting. DO NOT BLOCK EXITS!
1.1.8 PRECAUTIONS DURING USE
Treat your EDB-2 with care and do not drop it, tread on it or subject it
to liquids, extreme heat/cold or rough handling.
Switch off power supply when EDB-2 is not in use for >1 hour.
1.1.9 MINIMISING PLUG IN AND SWITCH ON NOISE
To minimise plug in noise connect cables in and out to instrument/Mic
and to PA or amp etc. while EDB-2 is off or on Standby. Ensure that
Standby has been engaged for at least 2 seconds before switching on.
If requiring to change input cable while live, engage Mute or Standby
first.
Switchcraft, Neutrik, Deltron, ST Pro & GH Industries offer Jack Plugs
for quieter switching.