Never pass the attachment points of the RipCord Webbing through any
loops on the harness.
Attach both carabiners to either the front attachment points or the rear
attachment points of a harness. Never attach the carabiners on both the
front and back of the harness, and never attach the carabiners to the
side of the harness.
Keep fingers clear of carabiners and harness attachment points when
descending. Loading may cause pinching.
Never permit the webbing lines to wrap around or rub against the legs,
arms, neck, other body parts or loose clothing of the Participant prior to
or during descent.
Never descend from alongside or above the QuickFlight Free Fall Device.
Prior to descent, ensure descent path and landing area are free of peo-
ple and obstructions.
When ready to descend, the Participant must be disconnected from any
platform anchor, and must step straight down off the platform.
NEVER DESCEND WITHOUT BEING CORRECTLY ATTACHED! ENSURE CARABIN-
ERS ARE ATTACHED TO DESIGNATED ATTACHMENT POINTS OF THE HARNESS,
THE LATCHES ARE FULLY CLOSED AND THE GATES ENGAGED IMMEDIATELY
BEFORE DESCENT. A GATE CHECK MUST BE PERFORMED WHERE THE GUIDE AP-
PLIES PRESSURE TO THE GATE OF THE CARABINER TO ENSURE THAT IT IS FULLY
LOCKED. FAILURE TO DO SO CAN RESULT IN SERIOUS INJURY OR DEATH.
The Participant should only hold on to the RipCord webbing by the
hand grip.
Always descend feet first and straight down using feet to fend off obsta-
cles and prepare for landing.
Upon landing, unclip the carabiners from the harness and allow the de-
vice to take up slack in the webbing and create tension before releasing
the webbing line to be retracted freely and fully back into the Quick-
Flight Free Fall Device.
IF THE WEBBING LINES DO NOT RETRACT ENTIRELY INTO THE DEVICE, FULLY
EXTEND BOTH WEBBING LINES AND ALLOW THEM TO SLOWLY RETRACT WHILE
MAINTAINING CONSTANT TENSION. DO NOT ATTEMPT TO PUSH WEBBING BACK
INTO THE NOZZLE DURING RETRACTION. IF THE WEBBING CONTINUALLY FAILS
TO RETRACT, CONTACT AN AUTHORIZED SERVICE CENTER FOR REPAIR.
Do not store wet webbing in the device. If webbing becomes wet,
extend the lines and allow them to dry fully. Do not speed drying with
heat.
30
headrushtech.com | +1-720-565-6885
