XTND 2K (40m) Extender Manual
3
QUICK SETUP
SYSTEM FEATURES
This quick setup guide will get your extender up and working in less than 5 minutes.
If you need to integrate IR control then please continue on to
page 5.
1.
Power off all displays and your HDMI source
device.
2. Connect the HDMI source to the Source Input
port on the XTND 2K (40m) Transmitter using
an appropriate HDMI cable.
3. Connect a display such as a HDTV or HD
Projector to the HDMI out port on the XTND
2K (40m) receiver using an appropriate HDMI
cable. We recommend that you use high-
speed HDMI cables no longer than 5 meters in
length.
4. Now connect a single Cat5e/6 cable up to
134ft/40m in length between the Cat output
port of the XTND 2K (40m) transmitter and the
Cat input port on the XTND 2K (40m) receiver.
1. Delivers uncompressed video and audio over
network cable
2. Supports the following resolutions:
a. 1080p/1080i/720p/576p/480p/576i/480i
b. Up to 24-Bit Deep Colour
3. HDMI loop out for a local display
4. Enables HD viewing in one additional room
5. If you are connecting a nearby or “local”
display use the HDMI loop out port. Connect
your TV to this port with an appropriate HDMI
cable.
6. Plug in the power supplies for the receiver
and transmitter.
7. Power on your HDMI source device, then
power on connected displays.
8. At this point the display should show the
video and audio of the HDMI source device
that is connected to the extender.
5. Stereo or multichannel audio including:
a. LPCM 7.1CH
b. Dolby True HD
c. DTS-HD Master Audio
d. Dolby Atmos
6. EDID management
7. Two-way IR
