Important MHUB S (8+8x8) 100 Rear Ports required for stacking.
Controlling the stack with a uControl Zone Processor
The Zone Processor (ZP) is a necessary component that is required to build a stacked system and must be
present in your LAN along with your MHUB S devices. When uControl detects this arrangement in your
network then the app will offer you the option to configure the collection of devices as a stacked system
and will set the MHUBs into stacked mode. At the same time the ZP will be instructed to change into
Controller mode and when this happens, any on-board IO present on the ZP (CEC, IR, RS232 ports) will
cease to function.
For best results HDA recommends that the ZP is connected to the LAN via its Ethernet connection
rather than WiFi which may introduce unwanted control lag/delay.
8
Summary of Contents for MHUB S
