www.hclfasteners.com
Read these instructions carefully:
ELECTRICAL
An Electrical supply represents a source of considerable potential energy. Precautions should be taken to prevent accidents.
– Electrical supplies must be disconnected before any adjustments, maintenance or dismantling.
– The Maximum allowable electrical supply should be observed.
COMPRESSED AIR
A compressed air supply represents a source of considerable potential energy. Precautions should be taken to prevent
accidents.
– Maximum operating pressure – 9.9 Bar
– Recommended air flow into unit – >50L/min.
Note. If the airflow is not achievable a longer time delay may need to be set to allow the jaws or piston to close fully.
– Use a 50 micron filter or better.
– Input air must be non-lubricated.
– Compressed air should never impinge in the body.
– Ports and pipes etc. should never be blocked by hand.
– Before connecting any pneumatic equipment to a compressed air supply, mountings, fittings, pipe work and electrical
connections should be checked for security, and all or any protective transit plugs removed.
– No pipe work alterations or removal of fittings should be attempted with air supplies connected
– Compressed air supplies must be disconnected before any adjustments, maintenance or dismantling.
– The maximum allowable operating pressures should be observed.
TRAINING
The control unit must not be used by persons not properly trained in its use. Be certain that you receive proper training from
your employer. If you have any questions contact your HCL representative.
WEIGHT
Control Unit – 6.7Kg
NOISE
– Sound pressure level is less than 70dB
– Vibration level is less than 2.5 ms
-2
Operation
- Warning & Safety Instructions
1.1
