11
1. Press the SET button on the Flow Sensor, and wait
60 seconds. If the red LED light (Wi-Fi) on the
sensor is not blinking, press and hold down the
reset button for 10 seconds, or until all the LED’s
on the sensor turn off, and then release.
Do not use the WPS-0100 Pressure sensor
for Wi-Fi Setup. The WFS-0100 is the master
sensor of the set. Both sensors will connect
to a wifi network when setup is done.
2. Go into your smartphone device settings and
then go into your Wi-Fi settings.
3. Select the TLBTUXXYY network. The XXYY number will correspond to the serial
number on the device.
4. Once you have selected the TLBTUXXYY network a prompt will display for the
password.
5. The password for the device is YYXXYYXX, where the XX is the first 2 digits of the
device numbers and YY are the last 2 digits of the device number. (E.g. TLBTU1234 ,
the password would be 34123412)
6. Once the password is input correctly then you will be taken to the main Wi-Fi
settings page on the phone. Wait unit you get a Green check mark beside the
TLBTUXXYY network before moving on.
7. Once you have the check mark then exit the Wi-Fi settings on your phone and
open the ThermoLinx App.
8. Upon opening the ThermoLinx App, after about 10 seconds a selection menu
will appear. Select Setup Device. If this menu does not appear there is a Setup Wi-Fi
button in the top left of the screen to press.
9. Once you are in the setup, a menu will appear. Type in the 4 digits in the TLBTU
section that correspond to your device numbers. TLBTU XXYY,
leave the ThermoLinx
position empty
CONNECTING TO A NETWORK (ANDROID)
100%
9:41 AM
WiFi Setup
--°F
Add Name Here
Connect to WiFi Now
Network SSID
Network Password
CHOOSE A NETWORK
Home Network
ThermoLinx
Home Network
1234
100%
9:41 AM
WiFi Setup
--°F
Add Name Here
Connect to WiFi Now
Network SSID
Network Password
CHOOSE A NETWORK
Home Network
ThermoLinx
Home Network
1234
