HBK FIT-AED-Kit, Operating Manual

Page: 18 / 48

FIT
®
-AED-Kit
INITIAL COMMISSIONING
16
7 INITIAL COMMISSIONING
If you have not already done so, download the PanelX program from the HBM website's
Weighing Technology section:
https://www.hbm.com/AED . Then install the program
on your PC.
Follow the procedure below to set up the devices:
u
Connect a transducer to the AED9401A or AED9501A.
u
Connect the AED or FIT load cell to the starter KIT.
u
Start the PanelX program.
u
Click on Scan ( Fig. 7.1 on page 17).
u
Select the interface you want to use to connect: CANopen, DeviceNet or RS232/485
for the diagnostics bus (
Fig. 7.2). If you are connecting the diagnostics bus via a
USB-to-RS232 adapter, select the relevant virtual port for RS232/485.
u
Set the baud rate you will be using.
u
Click on Scan.
This will run the bus scan.
u
If a connection is possible, the device is displayed below the interface.
u
Click on OK.
Switch to the other program menus to make further settings. Choose Options -> User
level -> Administrator to access all the settings.
Information
Download the operating manual and further information on AED and FIT from HBM's
website:
AED Digital transducer electronics or FIT7A Digital load cell .